Steelcraft-automotive 31270 TAILLIGHT GUARD Manuel d'utilisateur télécharger pdf

PARTS LIST:

1 Driver Side Tail Light Guard 1 Passenger Tail Light Guard

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY.

2. Open the rear door and remove the passenger side screws holding the taillight assembly by using

an 8mm socket wrench (Figure 1).

3. Grasp the taillight assembly with one hand and pull gently. WARNING: Be sure to pull straight out

to avoid possible damage. If is too tight, then use a large standard flat screw driver and something

like a cardboard backing of a note pad or towel to protect the paint from damage. Gently pry off

the outside of the taillight assembly out of the vehicle. This is the same procedure required to

change a burn out taillight in the assembly.

4. Carefully attach the passenger side Taillight Guard to the taillight (Figure 2). NOTE: Hold on to

the Taillight Guard so not to damage the paint.

5. Re-position the taillight with Taillight Guard onto vehicle and secure it with factory hardware

(Figure 3). NOTE: If the Mounting Brackets on the Taillight Guard do not fit properly, they can be

adjusted to fit properly by slightly pulling or pushing on them.

6. Once you mount the Taillight Guard, close rear door slowly and make sure that the Taillight Guard

does not interfere.

7. Repeat steps 2-6 for driver side Taillight Guard.

8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to add a

protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could

damage the finish.

For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild

soap may be used also to clean the Sidebar.

For gloss black finishes: Mild soap may be used to clean the Sidebar.

(Passenger Side Installation Shown)

Page 1 of 2 10/10/07

(AM)

INSTALLATION INSTRUCTIONS

TAILLIGHT GUARD

02-08 FORD EXPLORER

PART NUMBER 31270 / 31277

Remove

These

Screws

Use

Factory

Screws

Insert TLG from top of taillight

1 2

INSTALLATION INSTRUCTIONS 1

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

PARTS LIST:1 Driver Side Tail Light Guard 1 Passenger Tail Light GuardPROCEDURE:1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

Page 2

Page 2 of 2 10/10/07 (AM)

Commentaires sur ces manuels

Pas de commentaire

Steelcraft-automotive 31270 TAILLIGHT GUARD Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Steelcraft-automotive 31270 TAILLIGHT GUARD. Steelcraft Automotive 31270 TAILLIGHT GUARD User Manual [es] [fr] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Steelcraft-automotive 31270 TAILLIGHT GUARD