Steelcraft-automotive 52200 GRILL GUARD Manuel d'utilisateur télécharger pdf (Page 3)

GRILLE GUARD

07-12 JEEP J/K WRANGLER

Page 3 of 4 3/27/12 Rev2(DP)

Driver Side Installation Pictured

Fig 3

Fig 5

Fig 2

12mm x 30mm Hex Bolt

(2) 12mm Flat Washers

12mm Nylon Lock Nut

Insert (1) 8mm Rod Bolt up

through opening in corner,

hole in Top Bracket and out

hole in side of frame upright

Reinstall the fill panel and mark the cut area on the

bottom of the panel straight up from the frame upright.

Start with a small opening and slowly enlarge the

opening to get the best fit around the brackets. Area

cut from fill panel pictured for example only.

Frame upright

(Fig 4) Pictured without fill plate for example only

(Fig 6) 2012 only: It may be a little easier to

install the 8mm hardware on Rod Bolt if you

temporarily move this factory valve out of

the way-do not remove or disconnect

Insert Bracket into the

opening and bolt in place

with special Rod Bolt

8mm Flat Washer

8mm Nylon Lock Nut

Open end wrench

Front

1 2 3 4

Pas de commentaire

Steelcraft-automotive 52200 GRILL GUARD Manuel d'utilisateur Page 3