Steelcraft-automotive 75010 BULL BAR Manuel d'utilisateur télécharger pdf

PARTS LIST:

Qty

Description

Qty

Description

Frame Brackets

12mm Washers

12*30mm Hex Bolts

12mm Hex Nuts

12mm Lock Washers

PROCEDURE:

1. Remove push type retainers from lower splash shield. Remove plastic splash

shield to access to mounting location.

2. Locate and remove bolts that hold the frame brace and bumper brackets to

vehicle.

3. Install frame bracket between lower radiator support and frame brace using (3)

existing bolts. As shown.

4. Cut plastic splash shield to allow brackets to pass through. See Cutting Instruction

sheet for guidelines on cutting. Reinstall plastic splash shield over brackets in this

same order removed.

5. Position the bull bar assembly to the lower frame brackets (outer side) using

12*30mm hex bolts,12mm hex nuts and12mm washers.

6. Align the bull bar assembly with the front of the vehicle and tighten all

fasteners.

DRIVER SIDE SHOWN

LOWER RADIATOR

SUPPORT

FRAME SUPPORT

EXISTING BOLTS

INSTALLATION INSTRUCTIONS

BULL BAR

2006-10 HONDA RIDGELINE PART# 75010 / 75010B

Pictures are only for

reference.

1 2

PARTS LIST: Qty Description Qty Description 2 Frame Brackets 8 12mm Washers 4 12*30mm Hex Bolts 4 12mm Hex Nuts 4 12mm Lock Washers PROCEDURE: 1

CUTTING INSTRUCTIONS The template works best is placed on top side-of splash shield (the side towards the vehicle). Locate two-oval slots that measur

Pas de commentaire

Steelcraft-automotive 75010 BULL BAR Manuel d'utilisateur