Steelcraft-automotive 70380 SPORT BAR Manuel d'utilisateur télécharger pdf

PARTS LIST:

1 Sport Bar 6 12-1.75mm x 30mm Hex Head Bolts

1 Driver/Left Mounting Bracket 6 12mm Nylock Nuts

1 Passenger/Right Mounting Bracket 12 12mm ID x 29mm OD x 3mm Flat Washers

2 3/8” x 1” Self Tapping Bolts

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS

CAREFULLY BEFORE STARTING INSTALLATION. CUTTING REQUIRED

2. Measure from the driver outer edge of the air dam 23” towards the inside of the car and mark the location.

Use a hack saw to cut a 1” x 3 ½” gap on the air dam (Figure 1). NOTE: Use the mark as center of the

cutting location.

3. Remove the driver side factory hex nut located on the cross member bar. This is the hex nut that mounts the

radiator support (Figure 2).

4. Locate the driver side motor mount bushing. Use a 15mm socket to remove the two front (small) bolts.

Proceed to loosen up the rear (large) bolt just enough so you can slide the Mounting Bracket in between

motor mount support and frame (Figure 2).

5. Slide the slotted opening on the Mounting Bracket around the radiator support bolt and between radiator

bracket and frame, while you slide the Mounting Bracket between motor mount bushing (Figure 3).

6. Once the Mounting Bracket is in place, use the included 3/8” x 1” Self Tapping Bolt to attach the outer front

facing Mounting Location on the Bracket to the factory hole on the cross member bar. Re-install the factory

hex nut and the two bolts removed from the motor mount bushing. Tighten all hardware at this time including

the large bolt on the motor mount bushing and frame (figure 4). Tighten large motor mount bolt to 75 ft lbs.

7. Repeat steps 2 – 6 for passenger side Mounting Bracket.

8. With help position the Sport Bar on the outer side of Mounting Brackets. Attach Sport Bar to Mounting

Brackets using the included (6) 12mm x 30mm Hex Head Bolts, (6) 12mm Nylock Nuts, and (12) 12mm Flat

Washers (Figure 5).

Page 1 of 3

8/9/07 (AM)

INSTALLATION INSTRUCTIONS

SPORT BAR

08 GMC ACADIA

PART NUMBER

1 2 3

Page 1

PARTS LIST:1 Sport Bar 6 12-1.75mm x 30mm Hex Head Bolts1 Driver/Left Mounting Bracket 6 12mm Nylock Nuts1 Passenger/Right Mounting Bracket 12

9. Level and adjust Sport Bar properly; and then tighten all hardware at this time.10. Do periodic inspections to the installation to make sure that

Page 3 of 3 8/9/07 (AM)12mm x 30mm Hex Head Bolts12mm Nylock Nuts12mm Flat WashersFig 5 Fig 6

Pas de commentaire

Steelcraft-automotive 70380 SPORT BAR Manuel d'utilisateur