Steelcraft-automotive 74150 BULL BAR Manuel d'utilisateur télécharger pdf

PARTS LIST:

1 Bull Bar 4 12-1.25mm Hex Head Bolts

1 Driver/Left Mounting Bracket 4 12-1.75mm Hex Head Bolts

1 Passenger/Right Mounting Bracket 4 12mm Hex Nuts

8 12mm Lock Washers

12 12mm ID x 29mm OD x 3mm Flat Washers

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS

CAREFULLY BEFORE STARTING INSTALLATION.

2. From underside of vehicle, use a10mm socket wrench to remove the 6 bolts holding the center plastic

shroud. Set center plastic shroud on a clean working area and use a hack saw to cut out the driver side tow

hook cavity (Figure 1).

3. Remove the factory tow hook located on the passenger side (Figure 2). NOTE: You will not be re-installing

tow hook.

4. Once you have cut out the driver side tow hook cavity of shroud, reinstall it back to the vehicle using the

same factory hardware.

5. Locate the passenger side Mounting Bracket and partially hang it from factory threaded holes on the frame

rail using the included (2) 12-1.25 x 35mm Hex Head Bolts (fine thread), (2) 12mm Lock Washers, and (2)

12mm Flat Washers (Figure 3). Repeat this step for driver side.

6. With help position Bull Bar on the outer side of Mounting Brackets. Attach Bull Bar to Mounting Brackets

using the included (4) 12-1.75mm x 30mm Hex Head Bolts, (4) 12mm Lock Washers, (4) 12mm Hex Nuts,

and (8) 12mm Flat Washers (Figure 4).

7. Align Bull Bar properly and then tighten all hardware.

8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective

layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.

Page 1 of 3 9/28/07

(AM)

INSTALLATION INSTRUCTIONS

3” BULL BAR

08-On NISSAN PATHFINDER

PART #

Driver Side

Mounting

Bracket

Passenger Side

Mounting

Bracket

1 2 3

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

PARTS LIST:1 Bull Bar 4 12-1.25mm Hex Head Bolts1 Driver/Left Mounting Bracket 4 12-1.75mm Hex Head Bolts1 Passenger/Right Mounting Bracket 4 1

Page 2 - Fig 4 Fig 5

For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used also to clean the Sidebar.F

Page 3 - 12mm Flat Washers

Page 3 of 3 9/28/07 (AM)12-1.75mm x 35mm Hex Bolts12mm Lock Washers12mm Hex Nuts12mm Flat Washers

Commentaires sur ces manuels

Pas de commentaire

Steelcraft-automotive 74150 BULL BAR Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Steelcraft-automotive 74150 BULL BAR. Steelcraft Automotive 74150 BULL BAR User Manual [es] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Steelcraft-automotive 74150 BULL BAR