Steelcraft-automotive 70290 BULL BAR Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

BULL BAR PART# 70290

PARTS LIST

(1) BULLBAR

(2) BRACKETS (DR.-PASS.)

(6) 7/16X1 ¼ HEX HEAD BOLTS

(6) 7/16 HEX NUTS

(12) 7/16 FLAT WASHERS

(2) 1/2X4 ¾ HEX HEAD BOLTS

(2) 1/2 HEX NUTS

(4) 1/2 FLAT WASHERS

PROCEDURE

1. REMOVE CONTENTS FROM BOX AND CHECK FOR DAMAGE. VERIFY ALL PARTS

ARE PRESENT. READ INSTRUCTIONS CAREFULLY.

2. REMOVE FRONT LICENCE PLATE AND LICENCE PLATE BRACKET. IT IS NOT

REQUIRED BUT STRONGLY RECOMMENDED. IF LOCAL/STATE LAW REQUIRES A

LICENCE PLATE, LICENCE PLATE KIT IS AVAILABLE.

3. DETERMINE PASSENGER AND DRIVER SIDE BRACKETS. REMOVE TOW HOOKS

AND PLASTIC RETAINER ( SEE FIG 1). INSERT BRACKET ONTO FRAME, USING 1-

7/16X1 1/4 HEX BOLT 2-7/16 FLAT WASHERS AND 1-7/16 HEX NUT. NOTE: 7/16 X 1 ¼

BOLT SHOULD BE FASTENED AT FAR END OF BRACKET FIRST

4. INSERT 1-1/2X4 ¾ HEX BOLT 2-1/2 FLAT WASHERS AND ½ HEX NUT THROUGH

FRONT PART OF BRACKET (SEE FIG 2.). LEAVE LOOSE

5. ATTACH BULL BAR ON OUTSIDE OF BRACKETS USING 2-7/16 X 1 ¼ HEX BOLT 4-

7/16 FLAT WASHERS AND 2-7/16 HEX NUT ( SEE FIG. 3)

6. LEVEL AND ADJUST BULL BAR AS DESIRED. TIGHTEN AND TORQUE BOLTS.

1 2

Page 1

INSTALLATION INSTRUCTIONS BULL BAR PART# 70290 PARTS LIST (1) BUL

Page 2

INSTALLATION INSTRUCTIONS BULL BAR PART# 70290 Fig 1 (Pas

Pas de commentaire

Steelcraft-automotive 70290 BULL BAR Manuel d'utilisateur